View source for Displaying Information on Grades and Geometrics Sheets - GG2002

<p class="h2_outtoc">Introduction</p>
The purpose of this document is to provide instruction and guidance on the creation of the various components that are included on the Grades and Geometrics sheets within each Construction Plan set.<br><br>

<p class="h2_outtoc">Geometrics</p>
The following items shall be annotated for all curves larger than five feet (5’) in radius, excluding triangular (“pork-chop”) channelization islands:
* Radius (R)
* Point of Curvature (PC)
* Center of Curvature (CC)
* Point of Tangency (PT)<br><br>

For curves equal to or less than five feet (5’) in radius, the radius (R) and Center of Curvature (CC) shall be annotated on the Grades and Geometrics sheets.<br><br>

When displaying geometrics for channelization islands (“pork-chop” islands), the Center of Curvature (CC) points at the three corners of the island shall be annotated.<br><br>

If curb ramps are present within the project limits, the location where the curb ramp interfaces with the roadway shall be annotated. The annotated point shall be at the center of the curb ramp opening where it interfaces with the roadway. (See attached plan sheet).<br><br>

==== Grades ====
The following tables are based on two of the most common scenarios designers will encounter on their projects. The first one is an uncurbed typical section and the second is a curbed section. These tables provide the minimum locations that grades should be annotated on the plan sheets to provide sufficient data for construction layout.<br><br>

If profiles are not provided within the Construction Plan set, coordination with the Project Manager is needed to determine what supplemental information should be provided.<br><br>

'''Section #1'''						
* Hot-Mix or Concrete Pavement, without curbing.
* Travel Lanes = 12’ @ 2% Cross Slope
* Shoulders = 10’ @ 4% Cross Slope<br><br>

'''Section #2'''						
* Hot-Mix or Concrete Pavement, with curbing or curb & gutter.
* Travel Lanes = 12’ @ 2% Cross Slope
* Shoulders = 10’ @ 4% Cross Slope<br><br>
 
{| class="wikitable"
|+ '''Tangent Sections'''
|-
! '''Linear Feature''' !! '''Section #1''' !! '''Section #2'''
|-
| Centerline || No grades displayed. || No grades displayed.
|-
| Pavement Cross Slope Break Lines || No grades displayed. || No grades displayed.
|-
| Outer Edges of Shoulders || No grades displayed. || Grades displayed at 50’
intervals, coincident with
the centerline stationing.
|-
| colspan="3"|Note: Pavement cross slopes are typically annotated near each match line, and where changes in cross slope occur. (Ex: Outside shoulder converts to a turn-lane and cross slope rotates from 4.0% to 2.0%.)
|}

{| class="wikitable"
|+ '''Superelevation Transition Sections'''
|-
! '''Linear Feature''' !! '''Section #1''' !! '''Section #2'''
|-
| Centerline || Grades displayed at 25’ intervals, coincident with the centerline stationing. || Grades displayed at 25’ intervals, coincident with the centerline stationing.
|-
| Pavement Cross Slope Break Lines || Grades displayed at 25’ intervals, coincident with the centerline stationing. || Grades displayed at 25’ intervals, coincident with the centerline stationing.
|-
| Outer Edges of Shoulders || Grades displayed at 25’ intervals, coincident with the centerline stationing. || Grades displayed at 50’
intervals, coincident with
the centerline stationing.
|-
| colspan="3"|Note: Pavement cross slopes are shown at the following points:
* Beginning and end of tangent runout.
* Beginning and end of superelevation runoff.
* Beginning and end of full superelevation.)
|}

{| class="wikitable"
|+ '''Full Superelevation Sections'''
|-
! '''Linear Feature''' !! '''Section #1''' !! '''Section #2'''
|-
| Centerline || No grades displayed. || No grades displayed.
|-
| Pavement Cross Slope Break Lines || No grades displayed. || No grades displayed.
|-
| Outer Edges of Shoulders || No grades displayed. || Grades displayed at 50’
intervals, coincident with
the centerline stationing.
|}

{| class="wikitable"
|+ '''Intersections'''
|-
! '''Linear Feature''' !! '''Section #1''' !! '''Section #2'''
|-
| Centerline || Grades displayed at 25’ intervals, coincident with the centerline stationing. || Grades displayed at 25’ intervals, coincident with the centerline stationing.
|-
| Pavement Cross Slope Break Lines || Grades displayed at 25’ intervals, coincident with the centerline stationing. || Grades displayed at 25’ intervals, coincident with the centerline stationing.
|-
| Outer Edges of Shoulders ||  Grades displayed at 25’ intervals, coincident with the centerline stationing. || Grades displayed at 25’ intervals, coincident with the centerline stationing.
|-
| Radius From Mainline to Side Roads || Grades displayed at 10’ intervals along radius and at sag points to verify proper drainage. || Grades displayed at 10’ intervals along radius and at sag points to verify proper drainage.
|-
| colspan="3"|Note: Additional spot grades may be needed throughout the intersection to depict intended direction of drainage flow.
|}